hi
i follow the OTA user's guide to have a experiment base on the homeautomation application.and when I used the OTA dongle as coordiantor i had a successful experience.
when i used the OTA dongle as a coordiantor,and the end devices can join the network formed by the OTA dongle, and when an end device join the network the OTA Console application will display the end device's infomation immediately.and if i want to updata the firmware as long as i click the Image Notify.
but in my opinion,the OTA dongle cannot be used as an coordiantor,because the network has been builded by an another coordiantor before upgrading the firmware of the end devices . Am I right?
so after the network has formed, i used the OTA dongle as a router when i wanted to upgrade the firmware of end devices in the network.,i connected the OTA dongle with OTA Console Application via UART,and scans for PANID by the software,and the OTA Console found out the network PANID successfully after several seconds,then i scaned for devices and the result is unfortunate,the software can not get any end device's infomation for ever.
i have no diea to this phenomenon,i have read the user's guide again and again, and didn't found detailed discription about how to use the OTA dongle as an router to upgrade the end devices' firmware. Have somebody encountered this issue?
hoping your advice and help!
regards.