Hi, I have the 2541 key fob and the 2540 usb dongle. I have created a project using the SimpleBLEPeripheral as a starting point that works great on the 2541. I want to compare power signal between the 2541 and 2540 so I was going to use the same project on the USB dongle, however when I flash it to the dongle using IAR, it runs but it just doesn't advertise and light up as it does on the key fob.
Is there something I need to change in the project for it to work on the dongle?
I thought perhaps the buttons where on different I/O ports and causing a problem?
Many Thanks
