Hi,
I compiled and installed Prod-Hex for my CC2531USB dongle with no problem.
I sent commands as described in SWRA312 document, section "3.2 CC2530-ZNP startup procedure" for setting the network as coordinator by using ZTool.
Everything goes ok and I received ZB_START_CONFIRM command with a status of ZB_SUCCESS.
Then I turn my HA-enabled device and see the beacon requests. They are all replied from Coordinator but I can not query this device by querying its short address. I can see the "Association Request" and "Association Success" packages generated by the HA-device.
this is the capture:
Is there anything that I'm missing?
Any advice and help will be appreciated..
Aris Skorpideas