Hi all,
I have two end-Devices joined to coordinator as shown in figure, the 2-byte numbers below circles represents their network addresses.
I am using ZDO_BIND_REQ command from coordinator to bind two end-Devices as shown below, it fails.
End-Device-1 is Source and End-Device-2 is destination.
------------------------------------------------------------------------------------------------ ------------------------------------------------------------------------------------
|LEN | CMD0 | CMD1 | DstADDR| SRC IEEE |Src Ep |Cluster Id | Addr Mode | Dst IEEE |Dst | Src Ep |
-------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
| 0x17 | 0x25 | 0x21 | 0xc865 | 0x00137a000000bb7f | 0x2 | 0x0006 | 0x3 | 0x00137a0000008968 | 0x1 |
-------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
This command always Fails, is this correct?
Thanks & Regards
Anil