Hi Kjetil,
Thank you for your clarification. It´s very useful for me.
Yes, I tested these procedure, works fine. Since I have only one CC debugger in my hands now, I couldn't check the tx signal, but I am monitoring the CC2591 PAEN pin using a scope.
Maybe tomorrow I'll have the 2nd CC debugger, so I hope test the RX and TX.
Could you clarify another issue? As shown on PPW Configurator, all 18 channels has a start freq and end freq. But these values don't match with the PPW Commander.
Example: Channel 9 on PPW Commander use 2.442 GHz, but in PPW Configurator the range for change 9 is from 2.436 up to 2.440GHz. This happens also on channel 18 - I'm referring to prod_test_simplerf_tx configuration loaded in Product test screen of the PPWC Commander.
Thank you.
Regards,
RF_pts