Hello Anil, To receive reset indication message ZNP needs to jump to application code. Which can happen in two ways after reset...ZNP bootloader if configured for SPI mode waits for about 1 minute for host to either put it in the bootload mode or ask it to jump to application code. Which is done by sending a special character. Calling zapPhySpiRun() will cause the ZNP bootloader to jump to application code sooner than one minute and you will receive the Reset Indication message sooner or you can choose to not use this and wait a minute until the timer expires on the bootloader and it does a jump to the application code. Hope this clarifies the operation. Regards.
↧