Hi Sverre, thanks for your reply. I've already checked some of the proposed values from the DN022 with no luck at all. For example, I've tried to change:
AGCCTRL2 = 0x04
AGCCTRL1 = 0x00
AGCTRL0 = 0x91
As well as:
FIFOTHR=0x07
FREND1 = 0xB6
TEST2=0x88
TEST1=0x31
The devices are rearby but I've added a 30 dB attenuator to one of them to ensure that the AGC does not saturate. Do I need to try with the other values of AGCTLx as well? Even with bad register configuration, shouldn't I receive something? I will check tomorrow with a spectrum analyzer if the transmitter is sending something over the air, but since the driver works just fine with FSK/MSK I was assuming the same for ASK/OOK. Anything else I may be overlooking?
Kind regards,
Pere