Hello,
I'm trying to utilize the SimpleApp that was packaged with ZStack to collect A/D measurements from sensor nodes and output them to the UART of the coordinator. If I'm reading the documentation correctly, the SimpleApp is set up to do exactly that. I have a different board configuration and have modified hal_board_cfg.h to reflect changes such as LEDs etc. It seems that the coordinator starts up correctly as LED3 blips once then stays on (I only see a beacon request in the Packet sniffer though, followed by the 15second interval message)
The end device appears to start correctly, however LED3 blips continuously and MY_FIND_COLLECTOR_EVT trips every ~30 secs. I've attached the packet sniffer log.
Any help would be greatly appreciated.
Thanks,
Tyler
(Please visit the site to view this file)