Hello,
I have an analogue sensor which outputs voltage in a range of 1-2 volts. I also have a CC2540 MINI development kit and a PC. All I have to do is take measurements of my sensor output, transmit it via Bluetooth and display some kind of graph on my PC. The problem is I have no idea how to do that.
So far I have figured out that pin P0.6 on CC2540 is not connected and that it can be configured as analog input. So I should just connect my sensor output to this pin. Am I right?
However I am completely new to microprocessors not even talking about digital radio communication. I simply don't know where to start. I have already checked a lot of documents, forum posts and examples, but it didn't gave me too much clearance. I would be very happy if you could point me directly to some specific tutorials/posts/examples/code/software/anything ?
You see, it is for my university project and it have to be completed in a week. I thought it was going to be quite easy, but I was very wrong. Now I have nowhere to retreat.
Any help would be appreciated very much. Thank you!