Forum Post: CC Debugger and CC1200 daughter board - how to connect?

Dear forum,

I have tryed to connect the daughter board (CC1200EMK-868-930) to the CC Debugger from Ti. I have used the same wiring  to the cc112x from "CC debugger" manual.

But it does not work. The SmartRF Studio can't find the end device. I use the latest SmartRf Studio (7.1.12) and the actual firmware on CC debugger (041).

I checked the wiring twice. A CC1101 module work, a CC1111F32 work also.

I soldered the wires directy to the CC1200EMK-868-930 module (free RM 2.54 pin holes).

Could it be that the actual firmware from CC Debugger does not support the CC1200?

I hope some poeple can help me or can give tips.

Thanks.

Best regards, a new user.

Edit:

I tryed to use Vdd from CC Debugger -> no detection, and also separate Vdd on the daughter board -> no detection. The wires from connector to the board were only 5cm long.