We are in a situation where we need to handle signals send from two different transmitters; a TI CC1150 and a Linx TXM-433-LC (legacy). We cannot seem to configure the receiver to handle both transmitters well. We know that the center frequencies are slightly different for each transmitter; ~433.912 MHz for the CC1150 and ~433.928 MHz for the Linx.
So we are hoping for some advice on how to handle this situation,
We are now attempting to use the CC1101 in the specific mode of OOK asynchronous RX and are having difficulties. Here are the specifics:
- OOK
- 433.899994 MHz
- Channel 0
- 199.951172 kHz Channel Spacing
- 1.19948 kBaud (Manchester encoded)
- Asynchronous Serial Mode (Continuous RX tab in SmartRF)
-Jaden
