Hello everyone,
i have the following hardware:
- CC Debugger
- SmartRF05 BB battery board
- CC2530EM
I would flash an hex file into CC2530,plugged onto the battery board, using the CC Debugger.
When i connect the Debugger to the target connector (using a flat cable with 2x5 2.54mm connector) the status led on the debugger is ever red.
It doesn't detect the CC2530.
I have installed the required driver (the latest version 2.50) but i don't have solved this trouble.
Also, when i use SmartRF studio and SmartRF Flash Programmer tools, them detect only the Debugger but there isn't any trace of CC2530EM.
Have you any ideas about the problem?!
Thanks a lot!
Best regards.
Emanuele.