Hi,
I am using LogicPD eval board for OMAP L138. I am able to connect to AP. When i issue calibrator command to change datarate beyond 5.5Mbps, nothing comes out of station.
Below is the procedure followed
ifconfig wlan0 down
calibrator wlan0 plt power_mode on
calibrator wlan0 plt tune_channel 0 7
calibrator wlan0 plt tx_cont 50 1 800 0 7000 0 3 0 0 0 0 0 1 0 11:22:11:22:11:22.
The second parameter in the last command issued is data rate ( in the above command it is 1Mbps ), if i change that parameter i can go only upto 5.5Mbps. Any value above that i cannot see any packets out of my station
PS: I am capturing the packets through wireshark.
Did anyone faced this issue?
Regards,
Manjunath