While going through the sensor demo app, got some confusion, as listed below:
During start up one should press joystick center to start with a fresh known network state. If this key is pressed It writes the NV system with start up parameters with ZCD_STARTOPT_CLEAR_CONFIG & ZCD_STARTOPT_CLEAR_STATE set. Then zb_SystemReset(); is called.
1.Does this reset start the execution from very beginning i.e. from the main()? & How it is useful for cc2531EMK as specified in the comment.
2. At which state will the system clears the network config parameters in NV system with default value depending on the ZCD_STARTOPT_CLEAR_STATE .
3. when will the system reads & uses the network config parameters as given in the NV system
4. when a device powered on doesn't it write the nvsystem with default configuration parameters every time, if it does whats the necessity of the job.
5. which function reads the startup options & writes the default parameters in the nv system.