I have a small project based on SimpleBLEPeripheral. When I run it using TI's CC debugger and connect to it from a second BLE device, everything works fine, i.e. I can get/set parameters 1-5 as intended. But when the debugger is NOT plugged in, the simpleBLEPeripjeral immediately disconnects upon forming a connection.
Other than SimpleBLEPeripheral's off-the-shelf, I've added battery services. The code is running on my own development board, but I've verified this is not a power supply issue. I'm convinced that it's programmatic, but haven't come up with a genius way to debug without the debugger attached. FYI, I've turned off POWER_SAVING which I'de expect debug mode to override to PM0 if it were on, but my intent is to stay in PM0 anyway.
Any clever tips from the experts on where to look first could save me and other like me a lot of time. I could use a fresh perspective on this issue.
Thank you in advance.