Ok, if you want to just send power your register settings look good. From what I can see from your settings you have programmed to send a CW (unmodulated carrier wave).
If you use the 'continuous TX' tab in Smart RF Studio you have the following options:
- Tick the unmodulated button: The radio will send a CW.
- Tick the modulated button:
- Synchronous serial mode: A logic '0' or a logic '1' is sent dependent on the value on the pin used as input.
- Random mode: A PN9 sequence (random data) is sent.
I your case it sounds like the best option is to send a CW as you already has set up the radio to do.