HI Timothy Barr:
I met a problem when I want to change frequencies. The method I used to change frequencies as follows: first,send SIDLE strob to cc1121, then,write the
number of bytes which represent the frequency I want to FREQ2,FREQ1,FREQ0.Then strobe STX or SRX to cc1121，to send or receive the data.
I used the synchronous serial mode. But, when I send SIDLE command to cc1121, after configuring frequency, usually I can receive a serila clock from the CC1121,But sometime，I can't get the serial clk。 I don't know why there is no serial clk。DO you konw why?
Thank you！
