Thanks for the prompt reply.
The TrxEB eval kit comes with two TrxEB boards. Apparently, one board appears to work normally, but the other gives this problem.
Details of the board:
SmartRF TrxEB Rev 1.7.0.2
SN: 0x1588(problem) 0x1589(working)
I have tried to burn the new image.
-----------------------------------------------------------------------
- Using SmartRF Flash Programmer:
I have downloaded this image, and am trying to reprogram the MSP430.
1. Switch off the TrxEB
2. Connect MSP430-FET430UIF. (the direct USB connection from PC to TrxEB is not connected)
3. Switch On the TrxEB
4. Start SmartRF Flash Programmer., choose option "Program CCxxxx SoC or MSP430"-> MSP430. It is able to detects the port and MSP430F5438A device. I point it to the image location
5. Perform Actions
It complains "Not able to setup connection with MSP430F5438A!"
Is there anything wrong with my setup or the image?
When I try to program the working board, it complains with the same message.
Looking forward to your advice soon.
