We would like to set the maximum transmission power by using HCI_Write_Inquiry_Transmit_Power_Level to 4 dBm.
Questions:
1. Is this command on the PAN1327/TiCC256x supported?
2. If we set the max. inquiry power to 4 dBm will this value be used for any other communication over BR/EDR and LE links or for Inquiry and Page only?
3. If this setting is used for all links (BR, EDR and LE) would that mean that the transmit power level for the LE link is always 4 dBm?
4. If the answer for 3 is yes, could that result in situations in which the LE link is using a higher power as the BR/EDR links because BR/EDR links uses the LMP commands (LMP_incr_power , LMP_decr_power).
4. If we use HCI_VS_DRPb_Set_Power_Vector are the LMP commands for (LMP_incr_power , LMP_decr_power) still supported?
5. If the answer for 4 is yes, are LMP_incr_power and LMP_decr_power used to switch between these 15 power levels/steps?
6. If we use HCI_VS_DRPb_Set_Power_Vector the maximum output power for both GFSK links (BR and LE) is the same or are they different. We assume not because both links are using the same GFSK.