I can't program any of my four boards. It fail on erase flash. CC debugger with latest firmware has green LED and correctly detect device CC8521 and CC8531 in my case. I red some previous articles http://e2e.ti.com/support/low_power_rf/f/382/t/63012.aspx and there are informations about not functional crystal. I don't know if crystal works correctly. I have 48MHz crystal with parameters Load capacitance 18pF and ESR 80ohm max. On the board I have capacitors 16pF. In datasheet for CC85xx are parameters Load capacitance 16pF and ESR 60ohm max. I haven't much experience with crystals. Is it possible, that a slight different parameters are key of my problems? I have 3.27V on all VDD pins.
Schematics diagram added: (Please visit the site to view this file)