I haven`t read that section. I`ll do that, thanks. I want to configure all the 5 transceivers with 5 different time periods for the RX mode, so there`s no collision between them. I also noticed that, if the chip is in RX mode and the TX command strobe is given, but the Clear Channel Assesment shows that the channel is not clear, then the chip goes to idle after a while. May be I should synchronize this, too. Becaese if 2 of the transceivers go tо idle together at the same time and then they could go to TX at the same time and could try sending the data at the same time, too, right? This could cause a collision between these 2 right?
Best regards,
E.M
