Hi,
I have developed my own board with CC2531 where I have attached 1 more sensor (lets say sensor_X ). Now I want to use sensor monitor app to display for sensor_x . I got the source code from one of the post in this community. But I dont know VB so it will be difficult for me to make proper change at proper place. It will be very helpful for me if any one plz let me know where do I need to make changes. The format of the data packet I am sending from end device is given below.
pData [0]= temperature
pData [1]= voltage
pData [2]= sensor_x data
pData [3]= parrent short address [15:8]
pData [4]= parrent short address [7:0]
Thanks You
Regards
Biprangshu Saha