Forum Post: RE: CC2541DK-SENSOR kit - what software compiler to use with kit?
The TI CC254x Bluetooth Low Energy Software Developer’s Guide has the relevant information you are looking for.http://www.iar.com/en/Products/IAR-Embedded-Workbench/8051/
View ArticleForum Post: RE: WL18xx card on EVM3358 can not work well
Hi Nobu,You are throwing in too many unnecessary commands. You don't need all of those to construct the wl18xx-conf.bin file.Please try the following for MIMO configuration:cd <path to...
View ArticleForum Post: RE: cc1101 Tranceiver - next generation with better receive...
Have you looked into CC1120?
View ArticleClik here to view.
Forum Post: CC2564 HCI Write Link Supervision Timeout Command Disallowed
The Bluetopia stack (V1.2.1) attempts to increase the Link Supervision Timeout for a connection by sending an 0x0c37 (HCI_Write_Link_Supervision_Timout) command to the CC2546. The CC2546 always...
View ArticleForum Post: RE: TRF7970A Antenna
Why does the antenna on TRF7970A EVM or TRF7960ATB have a metallic finish such as lead? A solder mask (no colour, green or something else) wouldn't be enough?From my calculus a solder mask with a...
View ArticleForum Post: RE: CC1120 and CC1121 ASK data rates?
Thanks for that info Andrew.We are testing TI as well as the ADI7023 and the Microchip MRF89 transceivers. On paper the ADI radio looks good but the TI development kits and support are far ahead of ADI.
View ArticleForum Post: RE: Problem writing a little buffer into the Flash on Z-Stack 2.5
I've got it. I was putting on the osal_nv_init_item function a wrong parameter. I was putting the length with the wrong value, and maybe the ZCD parameter wrong too.The ZCD_NV_ANY is the id parameter.
View ArticleForum Post: RE: CC3000 SimpleLink Wi-Fi under Linux
Hi Peter, CC3000 in Linux is uncharted territory and is possible, although difficult due to the TCP/IP stack in the Linux kernel. You would need to override the Linux IP stack and do everything...
View ArticleForum Post: RE: AF_DATA_REQUEST_EXT using 64bit addressing when network size...
Hello, I was hoping to not change any of the table sizes, if possible. Lets say there are 200 nodes in the network. If the Coordinator sends a message using AF_SEND_DATA_EXT using 64bit addressing,...
View ArticleForum Post: RE: problems with the HF power amplifier
Hi RomanThe input voltage of the RX_1 and RX_2 should not reach ~10V, but instead you should see a demodulated signal for the input. The combination of the diode and the capacitors makes a...
View ArticleForum Post: RE: TiWi-SL CC3000 Programming the service pack
Hi,The reason both radio module parameters and the MAC address are stored first, is because of re-writing the EEPROM's FAT. By doing this, the content is actually "erased".Re-writing the FAT is...
View ArticleForum Post: RE: Does SimpleLink CC3000 support direct connection with laptop?
Please note that WiFi Direct is supported on certain TI processor platforms (i.e. Battleship game) like:http://processors.wiki.ti.com/index.php/AM335x_Starter_Kit#Linux_2
View ArticleForum Post: RE: CC2564 + Bluetopia stack for Stellaris???
Hi,Yes. We plan to release new demos for Stellaris next week.
View ArticleForum Post: RE: PAN1323 + MCU + Microphone/Speaker
Hi Aditya,You would need a codec to interface with microphone/speaker. You will find an example schematic with I2S audio codec in the kit manual here: http://www.ti.com/tool/dk-lm3s9d96
View ArticleForum Post: RE: Message Response Timeout
Same issue here. Thanks for BLE 1.2.1 fallback link.
View ArticleForum Post: Connection to LG Nexus 4? Android Beam
We're having trouble connecting the TRF7970A to the Broadcom BCM20793 chip on the Nexus 4 to receive Android Beam (FeliCa 212kbps / 424kbps).For the Android Beam, we notice that the phone polls at...
View ArticleForum Post: RE: Determining Phase Offset using CC430
Here detectorall is also a good place to buy a metal detector, and there are different types for you to choose from , There are many kinds of detectors, such as handheld metal detectors, safety metal...
View ArticleForum Post: RE: Difficulty getting CC2420 CW mode running
I have managed to fix my problem:"One possible error is that you did not explicitly select nullmac/nullrdc. By default, Contiki uses a duty-cycling MAC protocol, and that would create problems."Anyhow,...
View ArticleForum Post: CC2530 with LPC1347
HelloWe have designed a CC2530 RF front end.We were able to establish communication between two CC2530 radio front ends we designed using SmartRF studio setupThe CC2530 radio board [RF front end] are...
View ArticleForum Post: RE: CC2540 "The third-party INF does not contain digital...
I tried both methods of disabling the Windows 8 signature requirement at https://freevps.us/thread-6845.htmlAlthough both methods proceeded smoothly, when I tried to install the TI dongle, I still...
View Article