Forum Post: RE: Issue with Multi-role Operation in wl1271 Driver (Compat...
Hi Girish,Does above explaination answer your question?Are you able to validate multirole mode in wl1271?Regards,Abhijit
View ArticleForum Post: RE: CC1101+CC1190 - Transient Power
Thanks for your prompt reply.We have tried using ramping with the CC1101+CC1190 868MHz EM. Two things I observe:SmartRF Studio (1.10.3) seems to disallow the use of PA ramping when used with the...
View ArticleForum Post: RE: Who trusts packet sniffer? How to make it more efficient?
Hi,I've been told about mid-december, could be earlier, could be later.Best regards,Aslak
View ArticleForum Post: CC1101 and CC1190 - various questions
Hi, I am working with the CC1101 and CC1190 and have many related questions that I would like to run by someone experienced with TI radio chips. Sorry for stacking all of them at once. Answers or...
View ArticleForum Post: RE: SimpliciTI FHSS Power Consumption and Sleep Scheduling
I have performed measurements, and the current appears to be right around the RX current. When "FREQUENCY_HOPPING" is defined for an end device transmitting to an Access Point using the AP_as_Data_Hub...
View ArticleForum Post: RE: Not receive the expected coverage in CC1120 boards to 169 Mhz
Hi;What is the tolerance value of the 169 MHz antenna?Thanks
View ArticleForum Post: RE: Do I have to use the osal_memcpy in my Z-Stack Application?
Hi Harry, Thanks for your response, here are some of my further questions regarding your answers:1. regarding "I have never seen anything close to a memory move by the code". please check function...
View ArticleForum Post: RE: some questions about ez430-rf2480
Hello, Use the CC2530ZNP instead; it's an upgraded version of the CC2480 and includes many examples. The CC2480 is legacy and not recommended for new designs; hence the lack of support.--Derek
View ArticleForum Post: RE: ZAP+ZNP communication?
The application processor could be anything; from an 8-bit micro up to a PC.Also check out Anaren's Zigbee module:http://www.anaren.com/air/products/air-for-zigbee-standard-appsIt's ZNP based and has a...
View ArticleForum Post: RE: Bluetopia, SPP Mode Continuous Data Sending
Hi Stonestreet One,the values are as follows:#define HCITRANS_RX_THREAD_STACK_SIZE (450)#define DEFAULT_INPUT_BUFFER_SIZE 512#define DEFAULT_OUTPUT_BUFFER_SIZE 126#define XOFF_LIMIT 128#define...
View ArticleForum Post: Which antenna to use with TRF7960
In TRF7960 4watts PA, the document says that use a 30 by 40cm antenna with SMA. Who can show me the antenna?
View ArticleClik here to view.
Forum Post: Filling up CC2540's memory
I'm building off of the keyfob demo application and have run into a memory issue. I've gotten to the point where adding more code causes undesirable effects to happen. The device will stop responding...
View ArticleForum Post: RE: How to modify SampleLight to send other HomeAutomation command
Dears,You can refer to the following code to report temperature, which is derive from zcl_SendReportCmd and home automation profile spec. uint8 *pReportCmdBuf=NULL; uint8 *pReportCmdData=NULL;...
View ArticleForum Post: RE: .apk file to support CC3000FRAMEMK-L Out of Box Demos
Thanks Abhijit, Thanks you for your quick response. I am familiar with that documentation.Do you know if users have access to the individual .apk files available to support this solution?Thank you,Chris
View ArticleForum Post: RE: 2.4 GHz Inverted F Antenna
Since this is an evaluation board there are a bit more components than strictly necessary. C253, C254, C255 forms a pi-filter which can be used for filtering and/or matching. R256 and C257 will...
View ArticleForum Post: Possible TRF7970A datasheet error
Table 5-4 of the TRF7970A's datasheet says that when B4 of the RX Special Settings Register is set to 1, the gain is reduced by 7dB. In Table 6-14, it says the gain is reduced by 18 dB when B4 is set....
View ArticleForum Post: RE: Unstable RSSI signal in cc2540
[quote user="Yaniv Reibenbacg"]If you are getting around -30dBm in your RSSI it means the devices are too close to each other and the AGC(part of the HW) may not function right.[/quote]Can you please...
View ArticleForum Post: TIWI-SL CC3000 with Non-TI Micro over SPI
Hi,We are palnning to develop a wireless capable product using TIWI-SL CC3000 Wifi module with non-TI host microcontroller. Wireless communication wouldbe between our product and PC. We will be using...
View ArticleForum Post: RE: CC3000: bug in Netapp_ipconfig API ?
AbhijitThanks for your reply. - When will the next release be available?- Is there perhaps a code snippet you are able to send me in the meanwhile to patch the current version so that I can use this...
View Article